Pressure Treated Wood

What is pressure treated wood?

The external cladding for our garden rooms is tanalised and internally as standard comes with untreated timber, you’ll see that you have a choice between pressure treated and untreated wood. Untreated wood is exactly what it sounds like, just fresh, new wood.

However, pressure treated wood has been through a process that makes it longer lasting. The wood itself is placed in wood preservative, and then put into a vacuum. The vacuum forces all of that preservative deep inside the wood, meaning it gets completely saturated and is treated even on the inside.

This kind of treatment does two things. Firstly, it protects the timber against the damp, which in our climate is extremely important. This means that you can safely leave pressure treated timber outside, and even placing it in contact with wet soil is fine (though it’s advisable to avoid this if possible). Secondly, the chemicals that are in the preservative will also help to protect the wood against insects, so you won’t need to worry about critters eating your new garden room.

After Sales Treatments, why do I Need to Treat the Wood Further?

Given that you’ve already paid a little extra for pressure treated wood that’s supposed to be long lasting and durable, you might be wondering why on earth you’d need to do anything else to the timber. What you need to remember here is that although pressure treating does stop rot from damp, it doesn’t protect the wood itself against weathering (which doesn’t always mean damp!).

Just as an example, the next time you go to the garden centre take a look at the stacks of pressure treated timber they keep there. You’ll see that some pieces are cracked or warped. This is because pressure treated wood is bundled whilst still damp, and the pieces that were on the outside of the bundle dry too quickly in the sun and therefore get damaged. What you need to do is prevent this from happening, which is why the correct treatment is so important.

The bottom line is that even pressure treated timber will crack or warp if not taken care of properly, which means that little bit extra you paid to get wood that was treated to last longer will be a complete waste. When our timber has come out of the pressure treatment tank it then goes through a drying process where each piece is latted to allow air flow to pass through in a controlled process until it has a moisture content reading of between 9-12%.

It’s key to any tanalised building that treated saturated timber is allowed to dry in this way to avoid shrinking. Once it’s reached the required moisture content it’s important not to allow the water to get back into your timber, therefore, a topcoat treatment should be applied.